After the new floor is installed the profile is reduced by sanding.
Matching original hardwood floors.
An original farmhouse sink under a layer of dust in the basement perhaps or a good as new cast iron tub in the master bath.
Then consider as per other comments a.
Sometimes if there is not a lot of existing hardwood flooring it is just best to take up the old flooring and start from scratch.
Install the other areas raw unfinished and then have it all sanded at the same time and stained to match.
Instead consider having a custom mixed stain matched to the same.
And if you re lucky original hardwood floors underneath the bad.
Matching an existing color is a lot harder than sanding all of it and then staining it all the same color.
If matching in the middle of a big room you must finger joint with a unfinished hardwood and pretest stains prior to installation.
To make your floors match make sure that you install site finished hardwood floors in the new room and then refinish the old floors at the same.
The new boards should be slightly thicker.
Before beginning such a project there are a few things you will want to find out about your wood.
Matching the new floors to the old is imperative to give the house a complete look.
This thickness known as a wood s profile should match that of the flooring in other rooms to ensure a seamless look for the viewer.
You could consider first sanding back and refinishing the existing timber floors with an acrylic based finish that will be more neutral in tone and likely much easier to match in with tonally.
When matching new hardwood floors to existing hardwood flooring in your home it is important that you purchase planks that are of a corresponding thickness to the wood floors that are already installed.
In such instances matching new hardwood perhaps to an addition to the home a room previously floored with carpet or tile or to a heavily damaged area is a bit more complicated but definitely worth it in most cases.
Matching the new materials to the profile of the old flooring boards isn t necessary.